So I shot the remaining 40s I loaded using the jacketed loading chart, followed by a box of 1 grain reduced load. Saw a definite increase in consistency with the reduced load pushing the coated 180 grain bullet.
Last night when cleaning the FN I found an issue with the recoil guide rod assembly. The round loop on the end fractured into a heart shape. So were my original loads producing excessive recoil, a flaw in the material, or is the recoil from the 40 too much for that part? Physically it appears to be the same as used in the 9mm version. Regardless I ordered a replacement and a spare.
- - - - - - -
My 30cal carbine is a lot of fun to shoot. Short, light weight and low recoil. So a few weeks ago I loaded a dozen and tried them. They worked just fine. So I reloaded 50 more for additional reliability testing. Of course that requires more shooting :). The only issue is that the long, almost straight walled cartridge is a bit tricky to resize. Regardless of the amount of lube used, the die tends to push some of the brass towards the base creating a small ridge.
- - - - -- - -
For the first time ever I bought a used firearm that was not considered a relic. Back before there were such a variety of small 9mm pistols on the market, I bought a Kar PM9. That is the only striker fired pistol I have ever owned. I never shot the PM9 very well, so I was keeping my eye open for a similar sized single action. I'd shot both the Kimber and Sig versions better than the PM9. I was in a local shop for a different reason, and they just so happened to have a used Sig 938 for a couple hundred less that new. So I bought it. In my part of the world both tiny 9s are somewhat rare.
No comments:
Post a Comment